I'm looking to put an angled grease nipple in the position over the gear change lever. My thread gauge marked 7/32, 3/16, 24 fits it the best but can't find any angled nipples that have that thread.
Anyone have a sorce for these? Have I got the size right? It's not a Bullet box but from an Enfield twin.
Stuart
Grease nipple angled
Moderators: Dan J, Diesel Dave, Crazymanneil, Stuart
-
andrewaust
- Site Admin
- Posts: 719
- Joined: Mon Dec 04, 2006 12:24 pm
- Location: Australia
- Contact:
Re: Grease nipple angled
When in doubt try ebay 
!! Can't get it there I'd really say it's a hard to get item Stuart.
I'll see if I can find my catalogue from a leading supplier of engineering parts and have a look mate, sure there would be somewhere that sells them.
A
!! Can't get it there I'd really say it's a hard to get item Stuart.I'll see if I can find my catalogue from a leading supplier of engineering parts and have a look mate, sure there would be somewhere that sells them.
A
-
Stuart
- Site Admin
- Posts: 2227
- Joined: Fri Dec 01, 2006 9:08 pm
- Location: Horsham West Sussex, England
- Contact:
Re: Grease nipple angled
Don't worry mate. I've had to section out part of the battery braket above and this allowed me to get the mini grease gun I had right onto the nipple. I did look on ebay and found nothing with quite the right thread.